Kenwood TS-850S - Manual (Page 30)

he desired
ransmit.
MODE key
Press the FM / AM key to
alternate between AM and
FM.
RIT/XIT switch/control
SQL(Squelch) control
RF gain control
This control should be all the
way to the right.
TONE control
Turn the control to increase
or decrease the tone.
SLOPE TUNE control
II
jjust carrier level
M.CH/VFO CH control
This control is used to
change the frequency in 10
kHz steps during VFO
operations.
This control is also used to
select the desired memory
channel
during Memory
Channel Operation.
NB switch/control
NB 1 : For pulse type noise,
such as generated by au­
tomotive ignition systems.
NB 2 : Noise blanker 2 is used
for long duration pulse
noise, like the “wood­
pecker”.
(TRANSMISSION)
D Connect a microphone to the MIC jack.
Q Turn on the DC power supply and then turn the transceiver’s power switch ON.
Q A frequency is shown in the display.
Q Select AM with the MODE key.
Qj Enter the desired frequency.
Before transmitting check the frequency for activity so that you do not interrupt another QSO.
40 W
Q Press the microphone PTT switch, or set the REC/SEND switch to
SEND.
Adjust the CAR control so that the meter indicates as shown Fig.1.
Speak into the microphone and adjust the MIC gain control so that
the meter indicates as shown Fig.2.__________________________
Note
If the MIC gain control is advanced too far for clockwise, the
transmit signal will become distorted.
T-1-1-1-1 -1--1-- r
1 3 S 7 9 20 40 600B
IHIIIIIIHIIIQOOOOOOGOQOOOOQO
PWR I I I I
SVR
COMP
SvR oooaaaoooQoooooooooooooo
80 W
-Í - I > 1 PWR 1
--------- ALC -------------
SWR oooooooooooooooooooooo
Fig. 2