Kenwood TS-850S - Manual (Page 48)

Memory channel 91
14.000 14.010MHz
[II] Press Numeric key 2 while holding down the
SCAN key. Scanning will proceed thru the
range stored in channel 92.
Memory channel 92
21.000 21.010MHz
[III] Press Numeric keys 1 and then 2 while holding
down the SCAN key. Scanning will be repeated
within the ranges stored in channels 91 and 92.
Memory channel 91 Memory channel 92
14.000 14.010MHz 21.000 21.010MHz
I--------------- ...........---I-----------------------
4-12-5. Scan Speed
The scanning speed is adjustable from the front
panel by using the RIT/XIT control during SCAN
operations. Clockwise rotation increases the scan
speed and counterclockwise rotation decreases the
scan speed. This speed adjustment is effective in
both VFO and M.CH scan modes. Once set the
scan speed remains in memory until it is again
changed by the RIT/XIT control. You must be in the
SCAN mode in order to alter the scan speed.
The approximate scan speed adjustment range is
shown below.
700Hz
SEC
50Hz
SEC
20Hz
SEC
P01 P50 P99
If the RIT/XIT control is turned fully counterclockwise
(or clockwise) and you want to increase (or
decrease) the scan speed, turn the control back and
then rotate it.
4-12-6. Scan Hold
The Scan Hold function is selected by using the
Power on function selection described in Section 4-
10-15.
After you stop turning the TUNING knob during program
scan, scanning will stop for a while and then restart.
42