Uniden UST-9000 - Manual (Page 2)

Controls and Functions
Oil И И s
Ш Ш Ш H
Ш [7] [7] и и
и
и:
Front Panel Controls
1. Power On/Off - Turn the receiver on or off from this
key or the same key on the remote control.
2. C/Ku Band - Press to select either C band or Ku band
satellite signals depending on the LNB installed in your
system.
3. Memo Key - Press to enter satellite, channel, audio or
other information into memory.
4. Scan Key - Activates channel scan. Press once to scan
2 channels per second. Press for more than 1 /2 second
to scan 12 channels per second. Press the Scan key again
or any other key to stop.
5. Channel Up/Down Keys - Press once to change a
channel. Press more than I /2 second to change 8 chan­
nels per second. Release key to stop.
6. V/H Polarity Key - Press to change from horizontal to
vertical or vertical to horizontal polarity.
7. Skew - Adjust the skew pulse to fine-tune the
television picture. Press or - until you get the best
possible picture.
8. Video Fine +/- - Primarily for Ku band reception.
Press and hold the -I- or - key until a Ku band channel
is visible. Press momentarily to fine-tune the picture.
Some C band channeis may also need to be fine-tuned
by pressing the -t- or - key momentarily.
9. Audio 1 Keys - Adjust the frequency of the first audio
channel from 5 - 8.5 MHz. Press once to step 10 KHz,
press more than 1/2 second to change 80 KHz per sec­
ond. Initial setting is 6.8 MHz for all channels.
10. Audio 2 Keys - Adjust the frequency of the second
audio channel. Operation is the same as audio 1. Initial
setting is 6.8 MHz for all channels.
11. Mode Key - Press to change the audio mode from
mono to discrete, matrix, multiplex and back to mono.
12. N/W Key - Press to change the audio band from wide
to narrow or narrow to wide. Initial setting is wide.
13. Station Keys - Allows easy selection of your favorite
preprogrammed satellite video channels or satellite radio
channels. After selecting the station number, simply
press the call key to automatically tune to the
preprogrammed satellite and channel.
14. P. Lock - The parental lock allows you to block rec^"
tion of a specific channel. Select the satellite and chanft„.
for which you wish to block reception. Press the P. Lock
key. Whenever that satellite and channel are called the
video will be blank and the P.L. LED will light. To release
the parental lock call the satellite and channel, then
press the P. Lock key for more than 4 seconds.
15. Lock Key - Press to lock the memory. In the lock mode
the east and west keys will move the antenna +/- 10
counts for fine-tuning only. Press the Lock key for more
than 4 seconds to unlock the memory.
16. туре Key - Select the type of satellite. Operation is the
same as No. key.
17. No. Key - Select satellite number. Press once to select
next number. Press for more than 1 /2 second to change
4 numbers per second. Release to stop.
18. Call Key - Press to move antenna to satellite and chan­
nel shown in display or to tune in a preprogrammed
station number.
19. East and West Keys - Press once to change antenna
position by one number on the display. Press and hold to
move antenna until key is released.
20. DNR Key - Press to turn Dynamic Noise Reduction on
or off.
21. Preset Video Key - Press to activate the video stz,‘='^"
mode for easy access to your favorite channels.
22. Preset Audio Key - Press to activate the audio sta­
tion function for easy access to your favorite satellite
radio programs.