JVC SP-PWC60 - Manual (Page 16)

Connections Do not connect the power cord until all other connections have been made.
Connecting the powered
subwoofer
Center unit
System cord
(supplied)
A ^ --^
Align the A marks.
Powered
subwoofer
E®M^CPfl
Align the A marks.
Connecting to an analog
component
You can cnjo)' Ihe sound i.d an analog compi.uient.
Center unit fW
S-video cord
(not supplied)
Composite video
cord
(not supplied)
AUXIN(VCR)
ji w Mfc-
RCA pin plug
cord
(not supplied)
©I @1
VCR(®t3)or@@)
TV(@)
Cassette recorder (@)
® To composite video output
® To S-video output
(S) To audio output
NOTE
The signals input to the VIDEO jack of the VCR IN jacks will be
output only from the VIDEO jack ofthe Y'TDEO OUT jacks, not from
the S-VIDEO jack of the VIDEO OUT jacks.
Connecting to a digital
component
You can enjoy the sound of a digital component.
* DBS = Direct Broadcasting Satellite
NOTE____________________
• Only digital audio signals can be input when selecting “DBS” as the
source to play. (See page 17.) YV^hen connecting a video component
such as a DBS tuner, operate this system to listen to the sound.
Connecting a USB mass storage
class device
You can connect a USB mass storage class device such as a USB
flash memory device, hard disc drive, multimedia card reader,
digital camera, etc. to this system.
• After connecting a USB mass storage class device to this system
and selecting USB MEMORY as the source, the file control
display appears on the TV screen. (See page 27.)
USB cable (not supplied) Center unit (on the
front panei
NOTE
When connecting a USB mass storage class device, refer also to its
manual.
Connect one USB mass storage class device to the system at a time. Do
not use a USB huh.
You cannot charge the USB mass storage class tlevice while
connecting it to the USB MEMORY jack.
While playing back a file in a USB mass storage class device, do not
disconnect the device. It may cause a malfunction of both the system
and the device.
JVC bears no responsibility for any loss of data in the USB mass
storage class device while using this system.
YVhen connecting with a USB cable, use a cable less than 1 m (3.3 ft)
in length.
This system is compatible with the USB 2.0 Full-Speed (not
compatible with the USB 1.1).
Y”ou can playback the following types ot files in a USB mass storage
class tlevice (maximum data transfer rate: 2 Mbps):
- Music: MP3. WMA
- Picture: JPEG
- Movie: MPEG-4 (ASF), DivX (maximum frame rate of 30 fps for
progressive)
You cannot playback a tile larger than 2 GB.
YVhen playing a tile which has a large transfer rate, frames or sounds
may be dropped during playback.
This system cannot recognize a USB mass storage class device whose
rating exceeds 5 V/500 mA.
This system may not recognize some USB mass storage class devices.
This system may not play back some files even though their formats
are listed above.
Connecting the power cord
Make sure that all other connections have been completed.
Center unit y......... ....'p Powered
subwoofer
Power cord
(Supplied) Power cord
Piug into AC outlets.
CAUTION
Disconnect the power cord before cleaning or moving the system.
Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp and pull the plug so as not to damage the cord.
13