Note, Operating the tv, To set the manufacturer's code – JVC SP-PWC60 User Manual
Page 17: Slide the remote control mode selector, To tv, Press and hold 0/1 tv, Press enter, 5 release o/l tv, Operation, Important
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating external components with the remote control
NOTE
Manufacturers’ codes are subject to change without notice.
Set the cocies again after replacing the batteries of the remote control.
Operating the TV
7
2
3
4
To set the manufacturer's code
Slide the remote control mode selector
to TV.
Press and hold
0/1
TV.
Keep the button pressed until step 4 is finished.
Press ENTER.
Press number buttons (1 -9,0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Manufacturer
Code
Manufacturer
Code
I V C
O f
Samsung
12
Hitachi
t o
Sanyo
1.3, 14
Magnavox
02
sharp
06
Mitsubishi
0.3
Sony
07
PiUiasonie
04
, t l Toshiba
08
Philips
15
Zenith
09
RCA
05
* “01” is the initial setting.
5
Release O/l TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
■ Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
. Set the remote control mode selector to TV.
The following buttons are available:
Cl)/I TV:
Turns TV on and off
TV VOL +/-:
Adjusts the volume.
TV/VIDEO:
Selects the input mode (either TV or
VIDEO).
CH +/-:
Changes the channels.
1-10,0,=£10 (100-I-): Selects the channel.
TV RETURN:
Alternates between the previously selected
channel and the current channel.
NOTE
The operating buttons may differ depentling on manufacturers.
14