Toshiba TEC MA-1400-100 - Manual (Page 12)

EOl-11014
NUMERIC DISPLAY
AMOUNT (8 digits): Displays the numeric data» such as amount, quantity, etc.
DPT (2 digits): Displays the code which represents each Department key. It stays tit when
repeating the same department entry.
RPT (1 digit): Displays the repeat count of the same item. The count is indicated from
the second entry on, and only the last digit will be displayed even if the
count exceeds nine.
PLU (4 digits; the DPT, RPT and AMOUNT digits are commonly used for this purpose.):
Displays the PLU code when any PLU is entered. It goes out when
repeating the same PLU entry.
MESSAGE DESCRIPTORS (TRIANGULAR INDICATORS)
SLP: Lights up when a slip has been properly inserted to allow validation. It flickers to
require a validation when validation compulsory status has been programmed on the
last operation.
ALM : Lights up with the alarm buzzer to indicate that the last operation or numeric entry was
an error. To clear the error condition, depress the
[C] key.
REG : Lights up when a sale item has been entered.
{ - ) ; Lights up when a negative amount such as [RTN MDSE] or [ - ] key has been
operated. It also lights up when the [ST] or one of the total keys has been depressed
and the displayed amount is negative.
It lights up also when an amount is entered in the " El ** mode.
FS : Light up when a department or PLU item with a food stampable status is entered.
TXBL : Lights up when a taxable item has been entered.
ST; Lights up when the subtotal amount is displayed after the [ST] key has been
depressed.
TL : Lights up on a finalizing operation with the total amount displayed when a sate is
finalized without any amount tendered.
GG : When an amount tendering operation has been performed, this lamp lights up with the
change due displayed.
SHORT : Lights up when the amount tendered is less than the sale total with the shortage
TRF amount displayed.
Lights up also when all the sale balance are transferred to the new sale balance for
post charging.
- 6 -