5 replacing the ribbon cartridge, 6 replenishing the store name stamp with ink – Toshiba TEC MA-1400-100 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E01-11014
13.5 REPLACING THE RIBBON
CARTRIDGE
When the receipt and journal print is too light, replace the
Ribbon Cartridge in the following manner:
1. Remove the Ribbon Cover (Fig. 1).
2.
Remove the old Ribbon Cartridge by pulling it toward
you (Fig. 2).
3.
Install a new Ribbon Cartridge in the reverse order to
Step 2 above (Fig. 3).
4.
The Ribbon Cartridge is a consumable product. Be
certain to use a genuine Ribbon Cartridge supplied by
your TEC representative.
13.6 REPLENISHING THE STORE
NAME STAMP WITH INK
When the store name stamp is printed too lightly,
replenish the ink in the following manner:
1. Turn the Power Switch to OFF.
Cover.
Remove the Paper
2.
Withdraw the store name stamp with the protruding
part pinched between your fingers (Fig. 4).
3.
Apply ink to the pad on the rear side of the Store
Name
Stamp.
The
amount
applied
should
be
adjusted according to the desired darkness of the
printed message, but the limit of 2 cc should not be
exceeded. (The ink bottle supplied contains 5 cc of
ink.) (Fig. 5)
4.
Follow the reverse order of the instructions in Step 2,
and then attach the cover.
Stors Name Stamp
Ink
- 4 0 -