Toshiba TEC MA-1400-100 - Manual (Page 80)

EOl-11014
PLU TABLE PROGRAMMING OR CHANGING (Submode No. 4)
I o program new plus : “1 •
To change any programmed contents of
J
outside a sale.
PLUS (except the following case):
To change programmed contents of PLUs ~i
with sales data not zero.
J
Reset.
Mode Lock : SET
4 (@1=ORl -► I PLÜ Code I [PLUJ
1 to 9999
( I Whole Package Q’tv I [STJ)
0 to 99 (Split type PLU)
(STEP (A))
^ I
---------- (STEP (B)) —
I
-► I Preset Price I
max. 6 dig.
[AMT] -------------
for open PLUS
[DEPT]
linked
Depl.
-►Character Entries for [ST] —
PLU’s Name ;
{max, 12 characters
see CHARACTER
. *
ENTRIES, S
«ana IQ \ PLU name
page 18.)
Repeat for another PLU. (max. 800 PLUs)
[AT/TL]
* ' I PLU Code I fPLUy entry may be skipped if the PLU Code is sequential from that of
the PLU just set.
If this PLU code entry is skipped at very first PLU, the PLU code will automatically
programmed as PLU No. 1.
NOTES : 1) The Positive/Negative, Single-itemfltemized, Taxable/Non-taxable, Food Stampable/
Non-Food-Stampable status are determined by those of the department to which each
PLU is linked.
2) STEP (A) may be omitted if only the PLU name is set or changed. Likewise, STEP
(B) may be omitted if the PLU name is not set or changed.
3) If no name is set for a PLU, the PLU Code (such as “PLU 0001 will be printed as
the PLU name on sales receipts.
4) An error results at entry time if the linked department is an other income department.
- 2 8 -