Toshiba LF434 - Manual (Page 87)

TOSHIBA
6 F 8 A 0 . 7 7 0
To change the rate-of-change limit value:
The following example shows how lo change Ihe raie-of-changc limit value from 10,0 % to
15,0%.
Key operation Display example Desoriptirm
SET
□
K1: L I M I T RATE
10, 0 %
Press [SET] first to start the items selection sequence
and select Kl: LIMIT RATE from among the con­
figuration items using [ ► ] and [ ^ ] keys. Then
press [SET] again to display the current
•ate-of-chanfic limit value flO.O % in this example).
Pressing [ ► ], the cursor appears. Then press [ ► ] as
1--- 1
K1: L I M I T RATE many times as necessary^ to move the cursor to the digit
U
10, 0
% 10 be changed.
Change the value to ‘LV’ by pressing [ ^ ] five times.
▲
K1: L I M I T RATE
<Note)
□
15, 0 %
ilf necessary, move the cursor to the next digit to be
changed by pressing [ ► ], and change the value,).
Pressing [SHT], the cursor disappears and changed
SLl
K1: L I M I T RATE ratc-of-change limit value display flickers. Press [SET]
□
15, 0 % again to save the value.
SET Kt: L I M I T RATE Pressing [SBT], the system returns to the items selec-
□ tion sequence.
Notei If you try to set the value outside the valid range, an error message ^ K OVER SPEC
appears. Set the value within (he specified range.
To chiinge the control limit time, select the item K2: LIMIT TIME.
- 86 -