Toshiba 32HLX95 - Manual (Page 38)

Chapter 5: TV Guide On Screen™ setup
Setting up the TV Guide On Screen™ system (continued)
Screen 20: If your VCR stopped playing the tape after testing,
select Yes and press ENTER. Screen 21 appears.
If your VCR did not stop playing the tape after testing and
you want to test the same code again, select Test this code
again and press ENTER.
If you want to test a different code, select No and press
ENTER. Screen 19 appears.
Note: Many VCRs require testing more than one code.
Screen 21: Review the setup information displayed on your TV
screen (an example is shown below).
If the information on your TV screen is correct for your
setup, select Yes, end setup and press ENTER. Screen 22
appears.
If the information is incorrect, select No, repeat setup
process and press ENTER. Screen 1 appears.
Screen 22: Congratulations! You have successfully completed
TV Guide On Screen™ system setup. Press ENTER to
display screen 23.
Screen 23: This screen provides helpful information on using
your TV Guide On Screen™ system.
Press ENTER to exit the TV Guide On Screen™ setup and
watch TV.
I 2. To Vie» pro§râiti fetieos, press She GUiOE key on your W remote.
I To record a show, make sere your cable box is 0«. Fut s tape irt your
VCR, tune the device to tire liftC input, then turn the VCR OFF,
. Vou must redo TV G uide On Sffeen system setup if you:
• Move vaut TV ID 3 new ZiP or postai code
f Carrceicahie service or change cable boxes
' Change your VCR brand or model
Press Enter to contirtue.
TV Guide On Screen™ Reminder
The TV Guide On Screen™ system receives program listings
data through your Cable or over-the-air video signal. In
order to receive regular program listing updates, remember
to do the following:
1. Leave the TV in standby mode when it is not in use
(such as overnight or when you are not watching it)
by turning it OFF but leaving the power cord
plugged in.
2. If you have a Cable box connected, leave it ON.
3. If you have a VCR connected, turn it OFF when not
in use. (Do not unplug the power cord.) See page 16
for VCR connection instructions.
4. If you have more than one Cable system in your area,
you may be prompted to select which Cable system s
program data to download. If so prompted, follow the
on-screen instructions.
TM Turning off the TV Guide On Screen
automatic display feature
After you set up the TV Guide On Screen® system, the program
guide will display automatically (by default) when you turn on
the TV. To turn off the automatic program guide:
1. Press TV GUIDE on the remote control to open the TV
Guide On Screen™ system (if it is not already open).
2. Use ^ ► to select the Setup menu.
3. Use AT to select Change Default Options, and then press
ENTER.
4. Use AT to select General Defaults, and then press ENTER.
5. Set the Auto Guide option to Off
6. Use AT to select Done, and then press ENTER.
38 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.