How to program the timer, If a power failure should happen, I- on – Toshiba KV-5024A User Manual
Page 11: On of
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How to Program the Timer
(Before programming the timer, check to see if the current time is correct. If not, adjust the time according to the descriptions
given on the preceding page.)
Setting outline: Press the Sfrbutton to the desired alphanumeric characters at the blinking position, and then press the MEMORY
button to store these characters in memory.
For example, to record in 24-hour mode from 18:30 (6:30 PM) to 8:30 (8:30 AM) the next day, M01 (Monday Program 1)
Press the PGM button.
PGM
□
DISPLAY ON TV
MÓ
/-' - - - - -
ON
" ¿
-
OF
Press the SET{ -)/(+) buttons to set it to the programmed
day of the week.
-SET +
□ D
DISPLAY ON TV
- M Ó
i- ON
¿ - OF
When the + button is pressed...
■M01”* *M02^TU1^
C
•SU2-^DAY-
When the - button is pressed, the direction is reversed.
M01
M02
DAY
Monday 1 Program
Monday 2 Program
Daily
One setting allowed in each of these 15 groups.
Press the MEMO/?/button.
MEMORY
DISPLAY ON TV
□
MO 1 y.i; - - ON
(? - - : - - OF
¡2) Similarly, set the starting hour and minute as well as the
ending hour and minute using the SET button and
MEMORY button.
-SET+ MEMORY
DISPLAY ON TV
□ □□
:M0 /: 18 •• 38 ON
" ¿ 8 : 3 0 O F
Press the TIME MODE buttons to set the TIME MODE
“24".
TIME MODE
DISPLAY ON TV
0
0
M O I
¿"V
18
:
38
8:38
ON
OF
Notes
•To program a reservation for another day, press the
MEMORY button to blink the position indicating the day of
the week, then press the SET button to the desired
alphanumeric characters.
Then repeat the procedures from (
2
) through (|).
• To cancel a reservation, press the CFM/SKIP button. Press
the button again to return to display the programmed
recording start and end times.
DISPLAY ON TV
SAI
SKIP
SKIP
ON
OF
The current time will be displayed if the PGM button is
pressed.
DISPLAY ON TV
г-
8 - 3 1
FRI
1 1 : S 3 : 1 3
<?w
(T) Press the TIMER button.
The power source is switched off, and "TIMER" flashes on
the mode display.
Recording starts when the programmed day and time of week
is reached.
Notes
IF A POWER FAILURE SHOULD HAPPEN
• During power failure, "PW.FAIL" appears on the mode
display area.
Press any button to turn off the display.
If the power failure lasts less than 7 days, all programmed
memory will be retained.
This VCR should be plugged into a 120 volt outlet for at least
20 hours to fully charge the internal battery backup.
10