Chrysler 2008 Sebring Convertible User Manual
Page 46
BeltAlert
Programming
The Enhanced Warning System (BeltAlert
) can be en-
abled or disabled by your authorized dealer or by
performing the following steps:
NOTE:
DaimlerChrysler does not recommend deacti-
vating the Enhanced Warning System (BeltAlert
).
1. With all doors closed, and the ignition switch in any
position except ON or START, buckle the driver’s seat
belt.
2. Turn the ignition switch to the ON position, but do not
start the engine. Wait for the Seat Belt Reminder Light to
turn off and then proceed to the next step.
NOTE:
You must perform the following steps within 60
seconds of turning the ignition switch to the ON position.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver’s
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE:
Watch for the Seat Belt Reminder Light to turn
on while unbuckling and turn off while re-buckling the
seat belt. It may be necessary to retract the seat belt
partially after unbuckling it.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have success-
fully completed the programming.
The Enhanced Warning System (BeltAlert
) can be reac-
tivated by repeating this procedure.
NOTE:
Although BeltAlert
is deactivated, the Seat Belt
Reminder Light will continue to illuminate as long as the
driver’s seat belt is unbuckled.
46
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE