Cal Spas Genesis Portable Spa - Manual (Page 17)

2009 Genesis Portable Spa
LTR20091058, Rev. A
Clear
W
ater Plan
www.calspas.com
15
We recommend you use Cal Spas chemicals only.
Other brands of chemicals may have similar names
and/or usage descriptions but due to manufacturing
differences, use of other chemicals can increase
the likelihood of under- or over-dosing the spa
chemicals. Damage to the spa or spa’s components
from improper chemicals or chemical usage is not
covered under the spa’s warranty.
Prior to filling a spa for the first time, or after a routine
draining, you will want to follow this start-up plan to
extend water life and performance.
As with all chemical dosages listed in these Clear
Water Plans, start-up dosages are intended for
500-gallon spas. Please adjust the chemical dosages
to the capacity of your particular spa.
Clean the surface of the spa with Cal Spas “Multi- 1.
Purpose Cleaner”.
Apply a protective coat of Cal Spas “Fast Sheen”
2.
to the acrylic surface.
Fill the spa to the proper water level with normal
3.
tap water. (Do not use soft water.)
Use test strip and balance the spa water.
4.
Adjust total alkalinity (acceptable range is •
80-120ppm).
Adjust pH if necessary (between 7.2 to 7.8).
•
Pour in 16 oz of Cal Spas “Metal Protector” in the
5.
center of the spa.
Add Stain and Scale Prevention.
6.
Add either chlorine or bromine (but not both). 7.
Chlorine: Add two tablespoons of Cal Spas “Chorine
Granules” to the spa water.
Bromine: Add 2 oz of Cal Spas “Go Brom” to
establish a bromine base.
Add 2 Cal Spas “Bromine Tablets” to
bromine floater.
Turn on jets for 15 minutes. Leave spa uncovered 8.
during this time.
Put cover on spa and allow to heat up to desired
9.
temperature.
Starting the Spa with Fresh Water
Water level is very important to the operation of your spa . If the water level
is too low or too high, your spa will not operate properly . The water level
should be about six inches from the top when the spa is not being used .