Cal Spas Genesis Portable Spa - Manual (Page 7)

2009 Genesis Portable Spa
LTR20091058, Rev. A
Operating
Your Spa
www.calspas.com
5
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the
actual water temperature in degrees
Fahrenheit. The displayed temperature will
only be current after the pump has been
running for at least two minutes.
To display the temperature that the spa is
set to:
Press either the • Up or Down button. The
temperature setting will flash.
While the display is flashing, each time you press
•
the Up or Down button, the set temperature will
change up or down one degree.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
St • will light briefly on the main display. In this
mode, the heating system will automatically
maintain the set spa temperature. In the economy-
heating mode, the heating system will only activate
during filtration times.
Ec
• will display solid if temperature is not current
and will alternate with spa temperature if measured
temperature is current.
Economy mode will heat the water to the set
•
temperature while Sleep mode, indicated by a
SL on the main display, will also only activate
the heater during the filtering cycles but will
only heat the water to within 20°F (10°C) of the
set temperature. Like Economy mode, SL will
display solid when temperature is not current and
will alternate with actual temperature when it is
current.
Switching Modes
Press either the • Up or Down button followed by
the Light button.
Press the same sequence to switch to the next
•
mode.
Jets
Press the Jets button:
Once to activate low speed pump. •
Twice to activate high speed. •
Three times to turn pump off. •
Light
Press the Light button to turn on the light. Press it
once again to turn the light off. All optional lighting
such as the control panel light and cabinet perimeter
lighting is controlled by the Light button and will turn
on and off with the spa light.
Automatic Time outs
These features will automatically turn themselves off
during periods of continuous use:
Low speed pump After 2 hours •
High speed pumps After 15 minutes •
Spa light After 4 hours •
Operating Your Spa
Electronic Control Operation
Initial Start up
When first powered up, your spa will perform a self-diagnostic check and to into priming mode. The topside will
display PR to indicate this. Priming mode will be active for less than five minutes. When the spa has finished
priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa
will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.