Comtrol VS3000S - Manual (Page 15)

Hardware Installation Overview 15
Installing the Hardware
Hardware Installation Overview
Perform the following steps to install and configure your VS3000:
• Connect up to four VS3000 ISDN ports to the ISDN lines.
• Connect the appropriate Ethernet cable between your server or hub
and the VS3000.
• Install the VS-Link software (discussed in the appropriate software
installation section).
Identifying VS3000 Models
There are at present two versions of the VS3000: the VS3000U, for
North American use, and the VS3000S, for international use (or North
American use with an NT1 terminating unit).
If you are unsure of which version of the VS3000 you have, check the
Network Address (MAC) label on the back on the unit. The network
address is coded as follows:
VS3000U 00 C0 4E 01 xxxx North America
VS3000S 00 C0 4E 03 xxxx International
FCC Notice (Consumer Instructions)
1. This equipment complies with Part 68 of the Federal
Communications Commission Rules. On the outside of the
equipment is a label containing the FCC registration number. The
information must be provided to the telephone company:
FCC Registration Number: 5EVUSA-24608-DE-N
FIC: 021S5
SIC: 6.0 N
USOC Jack: RJ49C
2. FCC-compliant cables are provided with this equipment. This
equipment is designed to be connected to the telephone network or
premises wiring using a compatible modular jack which is Part 68
Compliant. See the Building the Cable section for details.