Comtrol VS3000S - Manual (Page 17)

Installing the VS3000 17
Installing the Hardware
• Do not place a jack where it would allow a person to use the
telephone while in a bathtub, shower, swimming pool, or similar
hazardous location.
• Protectors and grounding wire placed by the service provider must
not be connected to, removed, or modified by the customer.
Warning: Do not touch telephone wiring if lightning is present!
Installing the VS3000
Use the following procedure to connect the VS3000 to your network.
1. Write down the serial number and Network (MAC) of the virtual
server in the event that you need to call technical support.
Note: You can use the blank, peel-off sticker that was shipped with the
VS3000.
2. Optionally, mount the VS3000 into the rack using the enclosed
mounting brackets or mount the rubber feet.
Warning: If mounting the VS3000 into a rack mount unit, make sure
that the rack is not top heavy.
a. Attach the L brackets to the VS3000 using the screws supplied
with the unit.
b. Attach the L brackets into your rack.
OR
• Attach the adhesive feet to the depressions on the bottom of the
VS3000.
Table 2. Model and Serial Numbers
Serial Number* Network (MAC) Address*
00 C0 4E ___ ______
* The identification tag is located on the rear of the VS3000 unit.