Casablanca Fan Company Casablanca Ceiling Fan 6643050 - Manual (Page 15)

15
1 ON
ECE
23
4
5
A4 A4 A4 A4
+
+ +
+
– –
ADVAN•TOUCH CHANGING FREQUENCY SETTING
You will have to change the dip switch settings in the
remote if you are using more than one fan in the same
area and want to control them separately.
Step 1. At the circuit breaker or fusebox, turn the power off
for the fan you want to change.
Step 2. Open the battery door of the Advan•Touch control
and remove the fi rst battery on the left to gain access to the
dip switches.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed Advan•Touch fan(s).
Step 4. Re-install the battery in the proper polarity and the
battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power back
on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the
up and down buttons at the same time. Hold for a few
seconds. You will see the LCD Screen fl ash all of the graphics.
You should now have control of the fan.
ADVAN•TOUCH IF THE FAN DOES NOT WORK
If the fan is not functioning after installation:
Step 1. Check to make sure the batteries are installed properly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push the up and down buttons at the same time, within
20 seconds from restoring power.
Step 4. The fan should now function properly.
Note: All fans leave the factory set to ‘10000’.
Note: You may want to label your controls to
assure you do not mix them up.
Pressing the ‘SECURITY’ button will start the Security lighting
program. The controller beeps and indicates ‘SECURITY’. The
light will automatically turn ON and OFF in a seemingly random
manner over an eight and a quarter hour programmed cycle
that is designed to give the home a “lived-in” look.
Regardless of the light setting when switching to the Security
mode (lights on or off, dim or bright), the lights will increase
to high brightness and then begin the Security cycle. This
cycle is then repeated continuously until cancelled by pressing
the ‘SECURITY’ button.
At any time during the Security mode you may adjust the
fan speed, reverse the direction, operate in Auto Speed or
Winter, use Saver or run the Test mode without affecting
Security mode.
You may still turn the light ON and OFF (or OFF and ON)
manually for temporary lighting, but the light will continue
to operate automatically at its programmed times.
SECURITY FEATURE
1. On for 60 minutes (80% bright)
2. Off for 30 minutes
3. On for 120 minutes (30% bright) 4. Off for 60 minutes
5. On for 90 minutes (50%
bright)
SECURITY MODE CYCLE
1 ON
ECE
23
4
5
+ –
DIP SWITCH
LOCATION
A
DVAN
•T
OUCH
™