Cabletron Systems TRXI-24 - Manual (Page 32)

INSTALLATION
Page 3-3
3.3.1 Rack Mounting the TRXI
Refer to Figure 3-2 and perform these steps to install the TRXI in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the TRXI.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the TRXI.
Figure 3-2. Rack Mount Brackets Installation
3. With the mounting brackets installed, position the TRXI between
the vertical frame members of the 19-inch rack and fasten it
securely with the mounting screws (see Figure 3-3).
Figure 3-3. Installing the TRXI in the Rack
TRXI-24 TOKEN RING HUB WITH LANVIEW®
Screws (4)
Wall/Rack Mounting
Brackets (2)
Screws (4)
19-Inch Rack
TRXI-24 TOKEN RING HUB WITH LANVIEW®