Cabletron Systems TRXI-24 - Manual (Page 33)

INSTALLATION
Page 3-4
3.3.2 Wall Mounting the TRXI
When you wall mount the TRXI, the cable connections must face
down. Perform the following steps to wall-mount the TRXI.
Note : 1/4-inch Molly screw anchors for wall mounting are not included
with the TRXI.
1. Use the supplied screws to attach the wall mounting brackets to
the bottom of the TRXI as shown in Figure 3-4. There are two
brackets, one for each side.
Figure 3-4. Wall Mounting the TRXI
2. Select the wall location for the TRXI within 7 feet of a power outlet.
Warning : There is a potential SHOCK HAZARD if there is electrical
wiring within the wall that interferes with drilling for pilot holes. Select
a wall location where drilling pilot holes for the Molly screws will not
come in contact with electrical wiring in the wall.
Molly Screws
Wall Mounting Bracket
Molly Screw
Anchors
Bracket Screws