Cabletron Systems TRXI-24 - Manual (Page 35)

INSTALLATION
Page 3-6
3.4 SETTING THE RING SPEED SWITCH
The TRXI’s Ring Speed switch lets you select ring speeds of 16 Mbps
or 4 Mbps. The factory default setting of the Ring Speed Switch
is 16 Mbps. Figure 3-6 shows the location of the Ring Speed Switch
and the switch settings. You can access the switch through the air vent
with a small screwdriver.
To change the ring speed:
1. Turn off the TRXI.
2. Place a small screwdriver through the TRXI’s air vent to access the
Ring Speed Switch.
3. Use the screwdriver to slide the switch to the desired setting as
shown in Figure 3-6.
4. Turn on the TRXI.
5. Check that the Ring Speed LED indicates the correct setting.
Figure 3-6. The Ring Speed Switch
DISPLAY
TRXI-24 TOKEN RING HUB WITH LANVIEW®
RING SPEED SWITCH SETTINGS
4 Mbps 16 Mbps
Ring Speed LED Indicator
On = 16 Mbps
Off = 4 Mbps