Cymatic Audio LP-16 Manual - Manual (Page 10)

PRODUCT MANUAL PRODUCT MANUAL 19 18 MULTI-TRACK (MT) MODE OPERATIONS AND MENUS MULTI-TRACK (MT) MODE OPERATIONS AND MENUS
12.2.4. Foot Switch settings
The LP-16 can use a standard ¼” equipped footswitch to perform various functions. The foot
switch settings screen allows you to adjust what specific actions occur when you press the
attached foot switch.
Type: Adjust the “type” setting to tell the LP-16 if you are using a “normally open” or “normally
closed” type footswitch. Consult your footswitch’s documentation to determine which type you
have.
Function: Adjust this setting to configure what specific function the footswitch will perform, when
it is pressed
• Play: Pressing the footswitch mimics the top panel “play” button.
• Play and Pause: Pressing the footswitch will begin playback. A second press of the
footswitch will pause playback, and a third press will un-pause the playback.
12.2.5. Display settings
This screen allows you to adjust the LCD display’s contrast, as well as its brightness, in order to
ensure optimal readability at different viewing angles.
• Press the Up/Down buttons to choose between setting the contrast or the brightness
• Press the Select button to select the highlighted setting
• Press the Up/Down buttons to adjust the value of the highlighted setting
12.2.6. Format USB Device
The format function can be used to format an attached hard drive or thumb drive that is
connected to the Live Player.
This operation can be useful in the following scenarios:
• The attached drive has not passed the LP-16’s drive test, because it is not currently
formatted in the required FAT-32 disk format
• The attached drive has been previously formatted in the correct FAT-32 format, but has not
had its data blocks optimized properly by the computer it was formatted on, resulting in a
failure of the LP-16 disk test.
In these cases, formatting the drive on the LP-16 may allow the disk to pass, since the LP-16 will
format the attached disk with the best possible settings for using with itself.
ALL DATA AS WELL AS ALL PARTITIONS ON THE
THUMB OR HARD DRIVE WILL BE DELETED
WHEN THE FORMAT FUNCTION IS USED!