CDA SV500 - Manual (Page 15)

Care and Maintenance
Clean the panes of glass using a soft sponge and washing up
liquid.
Do not soak the glass in water.
Do note use abrasive cleaning products, metallic scrapers or
scouring sponges. These could scuff the surface and cause the
glass to shatter.
Rinse with clean water and dry off with a lint-free cloth.
The inner glass assembly can be removed for cleaning if
necessary. Each pane of glass has a black corner pad which
much be replaced in their original position, as shown in fig. 16.
Replace the inner glass assembly in the door so that L and R and
located on the hinge side.
Replace the inner glass so that PYROLYSIS faces you.
Replace the clean panes in the door, taking care to slot the
frame under the spigot next to the hinge, as shown in figure 14.
Reattach the frame by tightening it against the door until the
frame clicks into place.
Do not push down on the door itself as this may damage your
oven.
Finally remove the red stoppers from the hinge slots.
Fig. 15
Fig. 17
Fig. 14
CLAC
CLAC
Fig. 16
L
R
14