General settings and use – CDA SV500 User Manual
Page 7
6
General Settings and Use
Clock
To set the clock when the time and the clock indicator are flashing (for example, when the oven is first switched on) touch
or until the correct time shows on the display, then touch to confirm the selection. The oven will beep to confirm
the selection and the clock and clock indicator will stop flashing.
To set the clock once the time has been set (when the clock is not flashing) touch and hold for three seconds until the
clock and the clock indicator flashes. Touch or until the correct time shows on the display, then touch to confirm
the selection. The oven will beep to confirm the selection and the clock and clock indicator will stop flashing.
Please note: the clock will set automatically if no key is touched for eight seconds.
Minute minder
This oven is equipped with a minute minder to count down for a maximum of 60 minutes. To set the timer, touch so the
display flashes 0:00 and the minute minder indicator flashes. Touch or until the required time shows on the display.
The minute minder will set after eight seconds delay and starting counting down. To start the minute minder immediately,
touch .
The display will show the time remaining and the minute minder indicator will stay lit. At the end of the countdown, the
minute minder indicator will flash and the oven will beep intermittently for approximately 2 minutes. To stop the end of
timer alerts before that time, touch any key.
To check on the progress of the minute minder during cooking, touch until the minute minder indicator flashes and the
time remaining will show on the display.
To cancel the minute minder touch until the minute minder indicator flashes and then touch or until the display
shows 0:00.
General Settings and Use
Display brightness adjustment
Set the clock to 00:10.
Touch and together for 10 seconds until the display shows –CO–.
Touch or until the required brightness shows on the screen.
After eight seconds delay, the oven will confirm the setting. Then set the clock to the correct time of day.