Eagle Microsystems EI-2000 - Manual (Page 8)

analog output (AOUt), and diagnostic (dIAG). Press the UP or DOWN ARROW pushbutton
below to select another mode, and press the “enter” pushbutton to select the function:
Menu choice selection:
EI-1000: [DOWN ARROW] or [UP ARROW]
EI-2000: [RIGHT UP ARROW] + [RIGHT DOWN ARROW]
To make a selection, press…
EI-1000: [SELECT]
EI-2000: [RIGHT SELECT]
To exit the calibration/configuration/diagnostic mode, press…
EI-1000: [RIGHT ARROW]
EI-2000: [LEFT SELECT]
The user will be returned to the FPA menu. The user can either select another menu choice
using the UP ARROW or DOWN ARROW (plus SELECT) pushbuttons or exit back to the
weigh mode by pressing the pushbutton stated above.
CONFIGURATION
To enter configuration, either set the DIP switches to S1-1=ON, S1-2=OFF, and S1-4=OFF or
use the front panel access method.
EI-1000 PUSHBUTTONS
To select a parameter, press the UP ARROW or DOWN ARROW pushbutton; the parameter
label (Pxxx) is displayed and then its value is displayed (alternates the two).
To adjust a parameter, press the SELECT pushbutton; the current parameter value will flash.
Using the UP ARROW and DOWN ARROW pushbuttons, adjust the value to the desired
setting. Finally, press the SELECT pushbutton again to enter the new value.
EI-2000 PUSHBUTTONS
Select a parameter by the LEFT UP and DOWN ARROW pushbuttons, and adjust the value
by the RIGHT UP and DOWN ARROW pushbuttons.
P001 Operation (1 – 5)
This selects the operating mode for the meter. See the “operating mode” section of this
manual for a detailed description of each one.
P010 lb/kg (display only)
This displays the engineering unit, lb or kg, selected by S1-3. The user can change the units
DIP switch at any time; all values that were entered in pounds are automatically converted to
kilograms and vice versa.
P020 Used display enable/disable (ON/OFF)
If set to on, the used display is available to be selected via the select pushbutton.