ebm-papst ECI-63.XX-K4 - Manual (Page 81)

81
9 RS485 Communication
9.1 Communication method
Communication between users and the drive software takes place via so-called telegrams. Each program contains specified data, which has
to be received or sent. The drive software ignores telegrams that are not addressed to it.
RS485 communication is possible with the following parameterisation:
Baud rate = 115200
Number of data bits: 8
Number of stop bits: 1
Parity: even
9.2 Cycle time
The telegrams “COM_CRX_FAHRBEFEHL_DREHZAHL” and “COM_CRX_FAHRBEFEHL_POSITION” may only be sent every 10 ms maximum, as
otherwise working through the telegrams uses up too much computing time.
If the telegrams are sent faster (< 10 ms) information is lost. The command is incomplete and is not executed. This does not cause any
damage to the drive.
9.3 Commands
9.3.1 Commands (RX)
Command Value Comment, conditions
UART_CRX_FAHRBEFEHL_DREHZAHL 0x00 FE_SOLLDREHZAHL RS485
UART_CRX_FAHRBEFEHL_POSITION 0x01 FE_SOLLDREHZAHL
UART_CRX_PARAMETER_STORE 0x02 Save parameter from RAM in the EEPROM
UART_CRX_PARAMETER_WR 0x03 Write a parameter in the RAM
UART_CRX_PARAMETER_RD 0x04 Read a parameter from RAM
UART_CRX_STATUS_RD 0x05 Read status
UART_CRX_PARAMETER_RELOAD_DFLT 0x06 Read default parameters from EEPROM into RAM
UART_CRX_SOFTWARE_ID_RD 0x07 Read software ID
UART_CRX_BOOTLOADER_ID_RD 0x08 Read bootloader ID
UART_CRX_CUSTOMER_ACCESS 0x09 Access to parameters
UART_CRX_BACK_TO_BOLO 0x0B Request jump back to bootloader
UART_CRX_CUSTOMER PASS SET 0x0C Reset password