Castelle Office Direct OfficeDirect Storage Server - Manual (Page 8)

4
S TORAGE S ERVER U SER ’ S G UIDE
LEDs
There are six status LEDs on the front panel:
Front Panel LEDs
Reset Button
(IP/Password) To reset, press and hold until you hear 1 beep,
The password will be cleared, and its IP Address set
to the default value of 192.168.0.2, with a Network
Mask of 255.255.255.0
Uplink Button When connected to a hub, this button should be UP.
If connecting directly to a PC or Macintosh via
Ethernet, depress this button.
10/100BaseT
connector Use this to connect the Storage Server to your
10BaseT or 100BaseTX hub.
100BaseTX LED
(amber) This will be ON if the LAN connector is using
100BaseTX.
10BaseT LED
(green) This will be ON if the LAN connector is using
10BaseT.
Printer Port Standard parallel printer port. A printer connected
here becomes a "network printer."
Ready Normally ON.
This blinks during Startup or Shutdown, and turns OFF after
the shutdown is completed.
Alert
(Red) Normally OFF.
However, it will be On during the power-on self test. Once
the self-test is completed, it will turn OFF. If it stays ON,
there is a hardware error.
During a software upgrade, both the Ready and Alert LEDs
will blink.
Disk Full
(Amber) Normally OFF.
Blinking indicates the Storage is 98% full.
ON indicates the Storage is completely full.
Disk Flashes during normal operation, when the Hard Disk is
accessed.
LAN Flashes during normal operation, when data is transmitted or
received via the LAN.