Assembly / adjustment, 12 assembly / adjustment, Receiver and servo connection – Futaba 3PL 2.4GHz FHSS User Manual
Page 12: Receiver antenna installation, Ｎwarning, Install the r2004gf receiver on the car as follows
12
Assembly / Adjustment
Assembly / Adjustment
Receiver and Servo Connection
As you connect the receiver, servos and other components, do so in accordance with the
"Assembly Precautions".
Receiver Antenna Installation
Install the R2004GF receiver on the car as follows:
Note: The operating range may become shorter, depending on where the
receiver and the antenna are mounted.
ｎWARNING
ｊ
Install the antenna in the higher place as shown in the figure.
Keep the antenna as far away from the motor, ESC and other
noise sources as possible.
Put the antenna in the antenna tube to protect it.
ｌ
Do not cut the antenna.
Do not bend the coaxial cable. Doing so causes damage.
Antenna
tube
Antenna
Coaxial
cable
R2004GF
(CH1)
(CH1)
(CH2)
(CH3)
(CH4)
(B)
(CH3)
(CH4)
(CH2)
Connections when an E.S.C. MC230CR or MC330CR is used.
Receiver
Receiver
Power Switch
To Receiver
Battery
Steering Servo
Channel 3 Servo
Channel 4 Servo
Steering Servo
Throttle Servo
Channel 3 Servo
Channel 4 Servo
E.S.C.
Power Switch
Connects to Motor
Connects to Battery
Gas Powered Model