Futaba 3PL 2.4GHz FHSS - Manual (Page 9)

9 Before Operation
Transmitter T3PL-2.4G
Nomenclature / Handling
ｎ WARNING
ｌ Do not cover/hold the built-in antenna part of T3PL-2.4G transmitter
by your hand during running.
Do not put any conductive plate/sticker on the antenna part.
Otherwise, the operating range may become shorter.
Antenna (Built-in)
LCD screen
Power switch turned on: Beep confirmation
sound is generated and the model name is
displayed for about two seconds and then
the initial screen appears.
Steering Trim Lever (DT1)
Steering Wheel
Throttle Trigger
Grip Handle
Power Switch
Throttle Trim Lever (DT2)
When slid upward,
the power is turned on.
Adjusts the steering in small increments so
the model will run straight.
Turn model to left or right.
Channel 3 Switch
Turn channel 3 servo to left
or right.
Select Button
Press the Select button to select the
desired function screen.
Steering Dual Rate Lever (D/R)
Adjusts the throttle in small increments so the
model will not move at neutral.
Adjust the vehicle's steering sensitivity across
the entire range.
Digital trim DT1, DT2, and D/R operation
Push the lever to the left or right (up or down).
The current position is displayed on the LCD screen for about two seconds.
Each step is indicated by a tone. When the trim exceeds the maximum trim
adjustment range, the beep tone will change and the servo will not move
any further. Remember, the trims are digital so the position of each trim is
remembered for each model separately.
Control the speed of the model and movement
forward and backward.
(Initial screen)
' 
 y number display
'!! y voltage display
(*1)
(*1)
(*1)
(*1)
The antenna is inside of this part.
ｎ WARNING
ｊ A s w i t h a l l r a d i o f r e q u e n c y
transmissions, the strongest area
of signal transmission is from
the sides of the antenna(built-
in). As such, the antenna (arrow
direction) should not be pointed
directly at the model.