Futaba 3PM 2.4GHz - Manual (Page 55)

56
Functions
Condition 2 Selection / COND2
Condition 2 selection
1 Use the (+) or (-) buttons to select the on/off state.
2 When ending selection, turn off the power switch before use.
Calling the setup screen
1. Turn on the power switch
while pressing "SEL" key. 2. Next, use "SEL" key to select
the desired function screen.
Condition 2 Selection
In specific functions, two rates can be set up, and switched with the switch (SW1)
simultaneously during a run.
If this function is activated, SW1 is used only for this function, and it becomes impos-
sible to use it for other functions automatically.
When the switch (SW1) is operated, Condition 2 on/off state changes by turn. When
this function is turned on, the beep sounds and the pilot lamp blinks.
Related functions:
Steering speed
Steering EXP
Throttle EXP
ABS return amount
Brake mixing rate
Programmable mixing
Steering trim
Throttle trim
Steering D/R
Throttle ATL
LED Mode Selection / LED-MD
You can select your desired brightness of the pilot lamp. (Four steps)
LED mode selection
1 Use the (+) or (-) buttons to select the brightness of the pilot lamp.
2 When ending selection, turn off the power switch once before use.
Calling the setup screen
1. Turn on the power switch
while pressing "SEL" key. 2. Next, use "SEL" key to select
the desired function screen.
LED mode
(Min.)L-1 ~ L-4(Max.)