Futaba 6D, 6DN User Manual
Page 12
4. After setting the push rods on each Servo, using transmitter, actuate each Servo fully from left to right making
sure the rod will not hang-up on any position, otherwise the excessive current flow thru Servo will damage
the unit.
5. Noise (interference) signals should be avoided. For example, if two metal parts are in intermittent contact with
each other due to engine vibrations, noise signals are generated. When these signals enter the receiver, unex-
pected movements of the Servos can result. Therefore one of the metal surfaces touching each other should
be covered with an insulating material.
6. When the installation is complete, at least once, by all means, visit a nearby radio control expert or the deal-
er where the equipment was purchased and be advised on proper handling techniques and other items which
require attention. It is necessary while receiving this correct instruction also, to have the installation completely
checked.
Let's enjoy Radio control by taking the advice of experts and observing the rules of Safety.
11