Futaba 6D, 6DN - Manual (Page 7)

HANDLING THE RECEIVER AND SERVOS
1 . The FP-R6D receiver incorporates an 8
Bit integrated circuit and is made into
6-channel operation. The same inte-
grated circuit is also used for Four (4)
and Five (5) channel operation.
2. The Block connector sockets that con-
nects the different Servos are an inte-
gral part of the receiver.
3. The Block Connector sockets are po-
larized and each position is designated
on the receiver case. Therefore check
carefully before connecting the Servos.
Particularly care must be taken since
the power supply relay connector is
Red and the Aileron relay connector
is BLACK.
4. Since each Servo is built to the same
specifications, any Servo can be used
for any purpose.
5. There is a FP-S5L (Reversible Servo
Red Label) included in each set. This
Servo is convenient for throttle control
on shoulder wing models.
6