Futaba 6EX 2.4GHz - Manual (Page 19)

19
PMIX1/2 Programmable Mixer 1/2 (ACRO only)
Unlike the “wing mixing” function (explained later) where the channels to be mixed are factory-set, the T6EX-2.4GHz also
contains two programmable mix where you, the pilot determine the channels to be mixed. This could be used to correct
unwanted flight tendencies (by mixing rudder to aileron, or aileron to rudder for example).
To set up a programmable mix:
1. Enter the programming mode. Access the “PMIX” screen with the MODE key.
2. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing “INH”
display to change to a flashing “ON” display.
3. Push SELECT key twice to call the screen for selecting channels to control “MAS” (Master)
mixing. Then select the channel by pushing DATA INPUT lever . Channel 1 (aileron) in this
figure is assigned to the master.
4. Push SELECT key once to call the screen for selecting channels to control “SLV” (Slave)
mixing. Then select the channel by pushing DATA INPUT lever. Channel 4 (rudder) in this
figure is assigned to the slave.
5. Press the SELECT key three times to display the flashing % sign. Use the DATA INPUT
lever to set the percentage of mixing from -100% to +100% (depending on the direction and
distance you wish the slave servo to move).
6. Push SELECT key to call the screen for selecting the on/off switch. Then select the switch
by pushing DATA INPUT lever. CH5, D/R, or FLP switch (include the on direction) is
selectable. The “ON” is “always on”.
7. Observe how the controls on the model respond to be certain you have achieved the correct
mix and that the throws are as desired.