Futaba 6EX 2.4GHz - Manual (Page 29)

29
To select the swashplate types:
1. Enter the programming mode and use the MODE key to access the “SWSH” function.
2. To select swashplate type press the DATA INPUT lever upward or downward for about two
seconds. When you are changing swashplate type to 1-S, 3-S or 3-E, the 1-S, 3-S or 3-E on
the display flashes slow, becomes rapid, and then returns slow flashing with confirmation
sound.
3. Now set the swashplate type.
To set the swash AFR:
This function can be used only when you select the 3-S or 3-E swashplate type. There is no swash AFR setting with 1-S type.
This swash AFR function is for changing the direction and amount of servo movement on aileron, elevator, and pitch.
At first, set the linkage and servo horn length on aileron, elevator, and pitch servos by following the instruction manual that
comes with the model. Basically “EPA” (see page17) is set near 100% with these three servos. Set the servo “reverse” function
(see page16) so that the swashplate keeps horizontal and moves in the correct direction up and down when you operate pitch
control (up and down throttle stick).
1.Enter the programming mode and use the MODE key to access the “SWSH” function.
2. Swashplate types, Confirm 3-S or 3-E type is selected. If 3-S or 3-E type is not selected,
please see “To select the swashplate types” and set.
3. Use SELECT key to select the channel you wanted to set. Aileron channel “CHA” is
displayed at first and “%” is flashing.
Move the aileron stick left and right to set the direction and amount of movement on the
aileron servo by pushing up or down DATA INPUT lever. Aileron movement can be adjusted
from -100% to +100% .
4. Select other channels (elevator and pitch) by SELECT key to set the direction and amount
of servo movement in same manner as aileron channel setting.
“CHE” is elevator and “CHP” is pitch channel on the Display.