Futaba 6EX 2.4GHz - Manual (Page 28)

28
SW-T Swash to throttle mixing (HELI only)
This function corrects slowing of engine speed caused by swashplate operation at aileron or elevator operation.
To activate swash to throttle mixing:
1. Enter the programming mode. Access the “SW-T” screen with the MODE key.
2. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing “INH”
display to change to a flashing “ON” display. Now the mixing is on.
NOTE: The throttle to swash mixing function only operates in the Idle up flight mode.
3. Press the SELECT key to display the “CHA”. Use the DATA INPUT lever to set the
percentage of aileron to throttle mixing rate from 0% to 50%.
4. Press the SELECT key to display the “CHE”. Use the DATA INPUT lever to set the
percentage of elevator to throttle mixing rate from 0% to 50%.
SWSH Swashplate types selection & Swash AFR (HELI only)
This function can select from three swashplate types. Swash AFR can be set, if you choose 3-S or 3-E type
1-S: Independent aileron, pitch and elevator servos linked to the swashplate. Most kits are 1-S type.
&RONT
%LEVATOR
0ITCH
!ILERON
!ILERON
0ITCH

3
3-S: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and
right; with Elevator inputs, the three servos tilt the swashplate fore and aft; with Pitch
inputs, all three servos raise the swashplate up and down.
Front Elevator
Pitch
(Aileron)
Aileron
(Pitch)
3-E Type
3-E: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and right;
with Elevator inputs, the servo tilts the swashplate fore and aft; with Pitch inputs, all
three servos raise the swashplate up and down.