Futaba 7UAF, 7UAP - Manual (Page 12)

• FUNCTION AND DATA SETTING
Press the [MODE SELECT] To normal display mode
CH selection
Select the CH which is to be
set to F/S or HOLD with the
keys. (CH NO.
flashes)
Function selection
Select the function with the
keys.
+ : HOLD function
— : F/S function
Select the function for another channel by
repeating steps
and
F/S function selected CH servo operating
position setting
Set the flashing display to
"SET" with the
keys.
The channel
or
for which the
F/S function was selected is
held in the desired position.
Press the keys
simultaneously. (The servo oper-
ating position is set. At the same
time, data is automatically sent
to the receiver.)
To PMX1
*The F/S set data is automatically
sent every minute.
*The PPM mode does not have an
F/S function. (FP-7UAF)
*When using the B.F/S function,
set the throttle channel F/S func-
tion.
(F/S function setting)
When interference makes reception
impossible, the servos move to the
position set at the transmitter.
When the interference ceases, the
F/S function is reset.
(HOLD function setting)
When interference makes reception
impossible, the servos are stopped
in position just before erroneous
operation is performed.
When the interference ceases, the
HOLD mode is released.
F/S and HOLD functions
• F/S and HOLD can be set for all
channels.
• The F/S and HOLD functions can
be selected for each channel.
F/S
FAIL SAFE
-10-