Before using – Futaba 7UAF, 7UAP User Manual

Page 5

Advertising
background image

• BEFORE USING

• Charging the transmitter and receiver Nicd battery

*Use the special Futaba charger.
• The charging time is 15 hours.

[However when the battery was

not used for some time, charge and
discharge it 2 — 3 times. Otherwise,
the battery will not be charged even
after the specified charging time !

• Factory setting of transmitter modulation system

The transmitter modulation system (PCM/PPM mode) is switched by

data setting. (For the setting method, see P19.). However, it is set as

follows at the factory:

FP-T7UAP . . . . . PCM mode

FP-T7UAF . . . . . PPM mode

A fully-charged transmitter battery
can be used for about 10 flights of

10 minutes each. The airborne NR-

4J Nicd battery pack can be used
for about 6 flights when 6 servos
are used.

Notes: (PBC-8B)

1) First, connect to TX Nicad and

red lamp goes on.

2) Then, connect to RX Nicad after

connecting, L, E, D, changes
color from red to greenish red

(orange) which indicates that
both TX and RX Nicads are
being charged.

3) In case of separate charging, L,

E, D, color will be:
RX Nicad - Green

TX Nicad- Red

Receiver
Nicd battery NR-4J

Remove the charging cap

and connect the charger.

(NT-8LP inside)

Tx side

Rx side

Male

Female

Charger

LED

Power plug

FP-7UAPor FP-7UAF

• Changing the transmitter Nicd battery pack

• Changing the RF module to change the

frequency band

Remove the battery cover.

— 3 —

Battery cover

1 Remove the RF module.

Pull the RF module forward
while pressing these tabs to

the inside

2 Change

the

Nicd

battery.

2 Change

the

RF

module.

® side contact

-Nicd battery

(Only the NT-8LP

can be used.)

*Load the battery while paying careful attention to

the direction of the contacts.

Push in the new module,

while being careful not to

bend the pins, until the tabs

at both sides lock into place

with a "click".

*Use the special FP-TP-FM RF module for the FP-

7UAP and 7UAF. Other RF modules cannot be used.

•When the transmitter frequency band is changed, the

receiver frequency band must be changed also.

Refer to only the necessary items of the items enclosed in

Advertising