Futaba 8SSHP - Manual (Page 16)

B Pitch
A Inverted flight low-side trimmer
B Inverted flight high-side trimmer
C Inverted flight
FS switch
Fig. 33
• The inverted flight function
can be turned on and off
with the [c] inverted flight
FS switch on the trimmer
panel at the back of the set.
I N V E R T : Inverted flight
function ON
INH : Inverted flight
function OFF
• When the [C] switch is in the
INVERT (function ON) po-
sition, normal flight - in-
verted flight switching can
be performed with the [26]
Inverted
flight ON-OFF
switch at the side top cor-
ner of the transmitter.
* When the [26] switch is
pushed back, normal flight
is selected. At this time,
the pitch can be adjusted
with trimmers [3 , 4 , 5,
6 , and 7] as usual. When
the [26] switch is pulled
forward, inverted flight is
selected. At this time, the
pitch control servo, eleva-
tor servo, and rudder servo
are reversed and the pitch
control servo low-side and
high-side throws can be ad-
justed with trimmer A a n d
B.
When the [C] inverted flight FS switch and [26]
Inverted flight ON-OFF switch are switched,
the A inverted flight low-side trimmer and B
inverted flight high-side trimmer operate the
pitch control servo (servo connected to channel
6 of the receiver) as shown in the figure.
3 High side pitch trimmer.
Adjusts the high side pitch
from about 60% of the full
throw of the pitch control
servo as shown in Fig. 35.
Fig. 35
14
Fig. 34
Throttle lever
neutral
When switch [C] is set
to the INH position,
the pitch control servo
operates normally.
Can be adjusted and set over this range with
trimmer B
Can be adjusted and set over
Throttle lever this range with trimmer A
High High
When the [C] switch
is in the INVERT po-
sition and the [26]
switch is pushed back
(INVERT OFF)
[NORMAL FLIGHT]
When the [C] switch
is in the I N V E R T po-
sition and the [26]
switch is pulled for-
ward (INVERT ON)
(INVERTED FLIGHT]
Throttle lever
neutral
neutral Low