Receiver, servo switch, and battery connections, Pcm receiver fp-r118gp – Futaba 8SSHP User Manual
Page 24
PCM RECEIVER FP-R118GP
• System checking can be performed with this lamp.
•When the receiver and servo side Nicd is connect-
ed and this LED is on, radiowaves are not being
received from the transmitter, check to be sure
the frequency is correct. Checking is possible by
the lamp being on.
•When strong noise has been received, or the
radiowaves from the transmitter are intermit-
tently interrupted, this lamp will blink.
This usually is not a problem.
Remove the receiver crystal by
pulling it in this direction.
Receiver crystal
Receiver, servo switch, and battery
connections
AEC-3
Extension cord
PCM receiver
FP R118GP
Power switch
SWH-5 (R4-SWJ)
Charging connector
NR-4J
Fig. 59
Pay careful attention to the
connector polarity.
Fig. 58
Error lamp
Crystal
Fig. 56
Antenna wire
Antenna
wire
22