Futaba 9VAP - Manual (Page 42)

ADJUSTMENTS AND FLIGHT TECHNIQUES
Elevator-> Flap Mixing
Elevator -> Flap coupling can be helpful in square-cornered loops. A small amount of flap
deflection can make circular patterns smoother. CH2 and CH6 are used and the flaps are
usually set to move DOWN with application of UP elevator.
4) Set the mixing rate by moving the cursor to
Setting Method
1) Select the EDIT screen and move the cursor
to Line 2 with the cursor key, then dis-
play the MIXING screen by pressing the
program key. Move the cursor to the 2ND line
with the
cursor key.
2) Press the program key.
NOTE: 2 ->6 MIX cannot be used in the BASIC
mixing mode.
3) To activate the Elevator -> Flap mixing func-
tion, press the program key. If the 2 -> 6
MIX Switch is ON at that time, "ON" will be
displayed. If the 2 -> 6 MIX Switch is OFF,
then "OFF" will be displayed. To deactivate
5) Set the Flap Trim throw by moving the cursor
the UP or DN line with the or cur-
, or program key. To change
the servo operating direction, move the cursor
to the UP line and press the
key.
to the FLP-TRIM line with the or
cursor key and setting the throw with the
, or program key.
6) Return to the mixing screen by pressing the
program key.
the function, press the
[40]