Futaba 9VAP - Manual (Page 9)

•BASIC TRANSMITTER T9VAP CONTROLS.
Refer to the fold-out illustration in the back of the manual.
1. Aileron
2. Elevator
3. Throttle
4. Rudder
5. Landing Gear Switch
6. Flap and Trim Control (CH6) Knob
7. Spoiler (CH7) Knob
Controls the spoilers as CH7.
8. Pitch Control (CH8) Lever
Serves as Pitch Control High Side Trimmer in
THR -> PIT mixing
9. Idle-Up Lever
Sets engine idling speed during THR -> PIT
mixing
10. Flap Spoiler Elevator mixing switch
Upper Position: Elevator -> Flap mixing
Center Position: OFF
Lower Position: Flap
-> Elevator mixing
Spoiler
1 1. Snap Roll ON/OFF Switch
Snap function operates when pulled forward.
Switch is spring-loaded and snap function
turns OFF when released.
12. Aileron Dual Rate Switch
13. Elevator Dual Rate Switch
14. Rudder Dual Rate/CHS Switch
15. Programmable Mixing ON/OFF Switch
16. Throttle -> Pitch Control Mixing ON/OFF
Switch
Non-slip Adjustable Control Sticks
The length of the control sticks can be adjusted
to suit operator preference.
Part A Part B
Unlock Parts A and B by turning them in op-
posite directions as indicated by the arrows,
and adjust the control stick to the most com-
fortable length.
Adjustable Stick Angle
The horizontal angle of the control sticks can be
adjusted.
Turn this screw with a
Phillips screwdriver.
The open gimbal stick angle
can be adjusted from about
3° to the inside to 4.5° to
the outside by turning the
adjusting screw as shown.
Adjust the control stick to
the most comfortable angle.
Phillips
Screwdriver
Transmitter RF Module
Transmitter crystal to
switch frequency on
the same band, change
this crystal.
72MHz Band
53MHz Band
50MHz Band
To remove the module, pull
the module outward while
pushing tabs toward the
center.
A temperature rise in the RF module during use
is normal.
[7]