Futaba 9VHP - Manual (Page 21)

Auto Dual Rate
• Dual Rate functions may be switched ON and
OFF automatically, according to the Throttle
(CH3) control stick position.
1) Move the cursor to the "mode" position with
the or cursor key.
2 Use the or cursor key to select the
D/R function to be set to AUTO and press the
program key.
3) Use the and cursor keys to move
the cursor to "pos".
4) Set the Throttle stick at the point you wish
ON/OFF switching to occur, and press the
program key.
OFF Switch is set to OFF, Dual Rate will be
OFF.
• If the assigned D/R ON/OFF Switch is set
to ON, then D/R will be ON even if the
Throttle stick is still below the ON/OFF
point.
6) When the Throttle stick is moved above the
ON/OFF point, then D/R will be ON, regard-
less of the position of the D/R ON/OFF
Switch.
NOTE: Dual Rate ON/OFF Switch directions
can be reversed using the PARAMETER program
screen (See D/R SW DIR page 46).
5) When the Throttle stick is below the ON/OFF
switching point and the pertinent D/R ON/
In the example shown, the AIL Dual Rate function will be switched to D/R ON (Low Rate) when the
Throttle stick is moved above the 10% positon. AIL and RUD D/R functions are both set to Switch No. 3.
End Soft Key
Press the program key to return to the EDIT screen.
[19]