Futaba 9VHP - Manual (Page 9)

•BASIC TRANSMITTER T9VHP CONTROLS
Refer to the fold-out illustration at the back of the manual.
Aileron Control (Right and Left Cyclic on
helicopter)
Elevator Control (Fore and Aft Cyclic on
helicopter)
Throttle Control (Throttle and Collective
Pitch (T/C) on helicopter)
Rudder Control (Tail rotor on helicopter)
CH5 Switch Multiple uses depending on pro-
gramming by modeler.
• Landing Gear (fixed wing aircraft)
• Rate gyro output sensitivity switching (heli-
copter)
•COMBI Switch - Rudder offset, Idle-Up.
and Dual rate can be turned ON and OFF.
• Inverted flight switch
Hovering Pitch Lever — left side of transmitter
CH6 Control Lever (In BASIC mixing mode)
Aileron Dual Rate ON/OFF Switch
Elevator Dual Rate ON/OFF Switch
Rudder Dual Rate ON/OFF Switch
NOTE: Functions of the D/R switches can
be selected, combined, ON/OFF directions
changed, etc. (See page 46)
Revolution Mixing (Pitch ->• Rudder Mixing)
UP Side Knob
Revolution Mixing (Pitch -> Rudder Mixing)
DOWN Side Knob
Idle-up 1 ON/OFF Switch
Idle-up 1 Knob
Idle-up 2 ON/OFF Switch
Idle-up 2 Knob
Hovering Throttle Trim Knob
Throttle Hold Switch
Pitch control servo
total travel
Throw can be adjusted within this range
with the lever when the throttle stick is in
the neutral position.
CH7 Control Knob Pitch Trim Knob (If func-
tion activated)
CH8 Control Switch COMBI Switch (if
se-
lected) - RUD offset, Idle-Up, and D/R ON/
OFF
Aileron Trim Lever
Elevator Trim Lever
Throttle (ATL) Trim Lever
LOW HIGH
Servo travel by
throttle trimming
— right side of trans-
12 Rudder Trim Lever
13 High Pitch Trim Lever
mitter
Non-Slip Adjustable Control Sticks
The length of the control sticks can be ad-
justed to suit operator preference.
Unlock Parts A andB by turning them in op-
posite directions as indicated by the arrows,
and adjust the control stick to the most com-
fortable length.
Adjustable Stick Angle
The horizontal angle of the control sticks
can be adjusted.
Phillips
Screwdriver
Turn this screw with a
Phillips screwdriver.
The open gimbal stick angle
can be adjusted from about
3° to the inside to 4.5° to
the outside by turning the
adjusting screw as shown.
Adjust the control stick to
the most comfortable angle.
[7]