Futaba CGY750 - Manual (Page 9)

9
(1) S.BUS connection setting:
start display
Use the mode [+] or [-] keys to
navigate through the menu.
Setting ranges common: 1 16ch, DG1,
DG2, INH
WARNING
Always verify that the S.BUS function as-
signments match your transmitter’s function
(in the FUNCTION menu) assignments. If any
changes are made within the transmitter func-
tion assignments, then it will also be necessary
to make the changes within the S.BUS function
assignments.
S.
BUS
B
ASIC
S
ETTING
6LQFH6%86VHQGVDOOFKDQQHOV PD\EHOLPLWHGE\\RXUWUDQVPLWWHU RYHUDVLQJOHZLUHLWLVQHFHVVDU\WRDVVLJQD&*<IXQFWLRQ VXFKDV
$,/(/(RU3,7 WRHDFKFKDQQHO7KHFKDQQHODVVLJQPHQWVDUHSHUIRUPHGZLWKLQWKH>6%86@%DVLFPHQX
,IDIXQFWLRQLVQRWJRLQJWREHXVHGWKHQLWPXVWEHVHWWR>,1+@)RUH[DPSOHLIWKH$*1DQG(*1UHPRWHJDLQIXQFWLRQVDUHQRWJRLQJWREH
XVHGWKHQVHWWKHPWR>,1+@DQGWKH&*<ZLOOWKHQDOORZ\RXWRPDNHJDLQDGMXVWPHQWVZLWKLQWKHUHVSHFWLYHPHQX
S.BUS BASIC MAP
(2) S.BUS setting: Aileron channel [default: 1ch]
Using the data [+] or [-] keys to set the correct channel number.
(3) S.BUS setting: Elevator channel [default: 2ch]
Using the data [+] or [-] keys to set the correct channel number.
(4) S.BUS setting: Throttle channel [default: 3ch]
Using the data [+] or [-] keys to set the correct channel number.
(5) S.BUS setting: Rudder channel [default: 4ch]
Using the data [+] or [-] keys to set the correct channel number.
(6) S.BUS setting: Pitch channel [default: 6ch]
Using the data [+] or [-] keys to set the correct channel number.
(7) S.BUS setting: AIL gain channel [default: 9ch]
Using the data [+] or [-] keys to set the correct channel number.
(12) S.BUS data reset
This resets the S.BUS channel assignments back to the defaults. Press the data [+] key and [Exec
??] will be displayed as a confirmation. Press data [+] to confirm the reset back to the default set-
tings.
(10) S.BUS setting: RPM channel [default: 7ch]
Using the data [+] or [-] keys to set the correct channel number.
(11) S.BUS setting: GOV. on/off channel [default: 8ch]
Using the data [+] or [-] keys to set the correct channel number.
(8) S.BUS setting: ELE gain channel [default: 10ch]
Using the data [+] or [-] keys to set the correct channel number.
(9) S.BUS setting: RUD gain channel [default: 5ch]
Using the data [+] or [-] keys to set the correct channel number.
Push DATA
+/– key
Push MODE
+/– key