HONDA 1984 Civic Coupe - Owner's Manual - Manual (Page 133)

132
uu Operating the Switches Around the Steering Wheel u Brightness Control
Co
ntrols
Brightness Control
When the parking lights are turned on and the
ignition switch is in ON
( w *1 , you can use the
brightness control knob to adjust instrument
panel brightness.
Brighten: Turn the knob to the right.
Dim: Turn the knob to the left.
You will hear a beep when the brightness
reaches minimum or maximum. The i-MID will
return to its original state several seconds after
you adjust the brightness.
■
Brightness level indicator
The brightness level is shown on the i-MID
while you are adjusting it.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Brightness Control
Instrument panel brightness varies, depending on
whether the exterior lights are on or off. The
instrument panel dims to reduce glare when they are
on.
Pressing the (SEL/RESET) knob or the
(display/information) button switches the display.
If you turn the knob to the right until the brightness
display is up to max, the beeper sounds. This cancels
the reduced instrument panel brightness when the
parking lights are on.
The brightness can be set differently for when the
exterior lights are on, and when they are off.
Control Knob
002300 75° F miles
On i-MID
14 CIVIC 2D_SI-31TS86210.book 132 ページ ２０１４年１月２９日 水曜日 午後８時９分