Interlogix MCR205-1T/1S User Manual - Manual (Page 51)

IFS MCR205-1T/1S User Manual 45
802.3ah Setup
When enabling the 802.3ah OAM function, all 802.3ah OAMPDU packets will
trap to embedded CPU. Software will implement auto discovery procedure. With
hardware support, software controls the 802.3ah remote loop back procedure.
Hardware can also detect dying gasp event and interrupt CPU to send dying
gasp event notification OAMPDU. All other functions defined by 802.3ah are
implemented using embedded CPU.
When remote device is in loop back mode, hardware can support changing
looped test frame’s DA, SA or both as user defined. Hardware can also be set
not to change looped test frame.
This function provides 802.3ah Setup of the MCR205-1T/1S. Press the “Apply”
button to save the current configuration of the MCR205-1T/1S.
Figure 41: 802.3ah Setup Web Page screen
The 802.3ah Setup Web page includes the following configurable data:
802.3ah OAM State Disable or enable the 802.3ah OAM State function. Default mode is
Enable.
802.3ah OAM Mode Choose “Active” or “Passive” for 802.3ah OAM Mode. Default mode
is Passive.
Loopback Reply Disable or enable the Loopback Reply function. Default mode is
Enable.
Remote OAM Configure Disable or enable the Remote OAM Configure function. Default mode
is Enable.