Interlogix TruVision 360° - Manual (Page 9)

TruVision 360° Camera Bracket Installation Manual 7
To mount the 360° camera on a swan neck bracket
1. Pull the camera cables through the TVD-SNB
bracket tube and then attach the swan neck
bracket to the wall with the expansion screws (A)
provided.
2. Screw the cup base onto the swan neck bracket
and fasten with the locking screw, as shown (A).
3. Screw the three B screws into the cup base.
4. Remove the camera cover from the camera.
Open the small flap on the camera cover. Using
the hex wrench provided, unscrew the hex head
screw (1).
Using a flathead screwdriver, release the two
clips on the base of the camera (2) to detach the
cover (3).
5. Connect the cables to the camera.