iStorage datAshur Personal Manual - Manual (Page 6)

#6
iStorage datAshur Personal
®
Manual – v 31
www.istorage-uk.com
personal
4. How to change the User PIN
PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers e.g. 3-3-3-3-3-3-3
• Must not contain only consecutive numbers e.g. (1-2-3-4-5-6-7),(7-8-9-0-1-2-3-4),(7-6-5-4-3-2-1)
• Drive must
NOT be connected to a host
Note: If a mistake was made while defining a new PIN or the procedure was aborted,
the drive will retain the old PIN.
5. How to create a new User PIN
INSTRUCTIONS LED ACTIVITY
Press KEY Button
Enter
User PIN to unlock drive
(Factory default PIN 1,1,2,2,3,3,4,4)
and press KEY Button
will blink together
will illuminate together for approximately
4 seconds and then:
will blink indicating correct
PIN entry
Press and hold KEY Button for 3 seconds will illuminate together
While illuminated enter New User PIN
and press KEY Button
will blink in unison
Re-enter New User PIN
and press KEY Button
will illuminate and then
change to blinking
Insert datAshur Personal into USB port
blinks if 1 st and 2 nd entries match
blink alternately if PIN entry incorrect
All cryptographic parameters (including User PIN and Admin PIN) are zeroed after hacking detection
has been triggered by 10 consecutive failed attempts to unlock, or when the drive has been manually
reset (see section No. 12)
This state is evident by a solid lit RED LED indicator. It will be necessary to set a New User PIN by
following these instructions.
Once the
User PIN has been defined, a new encryption key is generated using the on-board random
number generator.
Configuring a New User PIN overleaf
when all cryptographic parameters have been zeroed
N.B.