Casablanca Fan Company Holliston C31UxxZ - Manual (Page 12)

10
Step 4c. Slide both the hanging adapter cover and
canopy cover ring on to the pole, then route the
wires through the 3.5" Perma•Lock downrod and ball
assembly as shown in Figures #4. Insert the downrod
into the motor coupling and turn it clockwise until it
stops turning, ensuring that the pole has bottomed
out.
tiP: the downrod has a tapered thread that is designed
to lock completely when installed correctly.
Step 4d. tighten the set screw with the Allen wrench
as shown in Figure #5 to ensure safe operation of your
fan. If it is tight enough, you should not be able to turn
the downrod counterclockwise with your hands. If in
doubt, tighten the set screw with the Allen wrench
until you cannot turn it any further.
Caution: Failure to fully lock in the
downrod before securely tightening the
allen set screw may cause the fan to
separate from the downrod and fall during
normal operation.
Figure #4
HANGING
ADAPTER COVER
TAPERED
THREAD
MOTOR
COUPLING
MOTOR WIRES
(LEAVE AT LEAST
6" LONG)
PERMA•LOCK™
DOWNROD AND
BALL ASSEMBLY
MOTOR
HOUSING
ASSEMBLY
ALLEN
WRENCH
ALLEN SET
SCREW
fan preparatIon - contInUed
ALLEN SET
SCREW
CANOPY COVER
RING
Figure #5