Casablanca Fan Company Holliston C31UxxZ - Manual (Page 17)

15
H
olliston
™
SwItcH HoUSInG and end cap InStallatIon
SWitCh houSinG haRdWaRe (not to scale)
Light kit adaptor assembly
SCReW PLuG
SCReW
#8-32
BottoM CaP
LIGHT kIT
PLate
SCReW
#6-32
CaP
Step 11a. locate the light kit adaptor assembly and
screw plug as shown in the switch housing hardware
section above. You will need to install the complete
assembly for no light kit installation.
Screw Plug
Light kit adaptor disassembly
Step 11b. locate and remove the one #8-32
screw that is attaching the bottom cap to the light
kit adaptor assembly as shown in Figure #2 and
remove the bottom cap. do not discard screws during
disassembly.
Step 11c. locate and remove the four #6-32 screws
from the cap and remove the cap. do not discard the
screws during disassembly.
Figure #3
Figure #4
BottoM CaP
SCReW , #8-32
BottoM CaP
Cap SCReW,
#6-32
CaP
NOTE: Locate the light kit adaptor as shown in Figure #2,
this adaptor plate will need to be attached to the fan during
fan installation for light kit or no light kit installation.
Figure #1
Figure #2
No LIGHT kIT - Installation:
NOTE: If you are installing your fan without a light
kit attached as shown in Figure #1, continue with these
installation instruction
note: do not discard screws during
disassembly, all screws will be needed
for other installation steps within this
document.