Operation power, Operation speed control, Operation reversing airflow – Casablanca Fan Company Holliston C31UxxZ User Manual

Page 28: Operation lights

Advertising
background image

26

®

3

oPeRation PoWeR

the

button is normally left in the on position. Always turn the power off

during cleaning or servicing the fan and during thunderstorms. It is also used to

exit or enter additional programs.

the

button must be left on to retain a previously set fan speed or light

level.

oPeRation SPeed ContRoL

FAN CoNtRol

oN - oFF:

A momentary

press of the FAN

button

CHANGE

SPEEd:

Press and hold

FAN button

longer than one

second

there are six individual speed settings for the fan; each speed is indicated

by an audible tone of increasing pitch.

to select the desired fan speed:

1. with fan off, press and hold the button labeled

. the fan blades

will start rotating at the slowest speed, and will increase in steps.

2. Release the button when the desired speed is reached.

the fan speed is now in memory and will automatically come on at the

same speed each time the

button is used. to maintain this level

of speed, turn the fan on by pressing

less than one second. to

lower speed, turn fan off, then on by pressing and holding the

button until the desired speed is reached. when the fan is on, you may

increase the speed by pressing and holding the

button until the

desired speed is reached, then release it.

oPeRation ReveRSinG aiRFLoW

The direction of airflow can be changed from down-

ward to upward or from upward to downward.

To reverse the airflow:

1. Make sure the

is on and blades are turn-

ing.

2. Press the

button.

note: A four-toned signal

indicates the command was

accepted by the fan. A few

seconds later the fan will slow

to a stop and then reverse

direction.

lIGHt CoNtRol

on - oFF:

A momentary press of the

LiGht button

ChanGe BRiGhtneSS:

PReSS and hoLd

LiGht Button Lon-

GeR than one

SeCond

to turn the lights off and on, press and release the

button for less than

one second.

1. First press/release of the

button- Both lights shall turn oN.

2. Second press/release of the

button- Both lights shall turn oFF.

3. third press/release of the

button – downlight turns oN only.

4. Fourth press/release of the

button – downlight turns oFF.

5. Fifth press/release of the

button – uplights turns oN only.

6. Sixth press/release of the

button - uplights turns oFF only.

to vary the light brightness at each touch level:

Make sure where you are in the sequence to the right.

to dim both lights at the same time:

1. Make sure you have the uplight on.

2. turn the light off, then press and hold the

button. After one second, both

lights will come on at their lowest setting and gradually become brighter or dim-

mest level if you continue holding the

button.

3. Release the

button when the desired brightness is reached.

oPeRation LiGhtS

Advertising